Upholstered buttons 29 mm 4 pcs.

Unit Price for 1 pcs. 4,56 €

Unit Price for 10 pcs. 4,10 € 4,56 € Unit Price for 100 pcs. 3,65 € 4,56 € Unit Price for 1000 pcs. 3,19 € 4,56 €

Klarna

The buttons consist of two parts. A top/front (the dome-shaped part with a metal eyelet on the back) where the leather or fabric is to be attached, and the bottom/back (the flatter part with a hole in the middle) which holds the button together. 


Facts 
Leather thicker than 0.5 mm is not suitable for attaching to this button.


Use 
The buttons are suitable as buttons on clothes or decorative buttons on cushions. 


Size 
The buttons are available in two sizes, 19 mm or 29 mm. Select size under variants. 


Material 
Aluminum


Installation instructions
1.    Cut a circle in the thin leather or fabric that is approx. 15 mm larger than the diameter of the button, that is approx. 35 mm or 45 mm. 
2.    Sew a strong thread into the leather/fabric all the way around a few millimeters from the edge. It is important to sew the grids in the same distance (approx. 3 mm) so that the leather/fabric is folded uniformly before it is mounted on the button. If the fabric/leather is evenly distributed all around, the result will be best, and it is easier to click the bottom part in place. 
Please note that it is a good idea to iron thin Vilene on the back of the fabric if the button is to be covered with some thin fabric. 
3.    Tighten the thread around the dome-shaped part, spread the leather/fabric and tie a knot. 
4.    The bottom part is shaped like a deep plate. When it is to be mounted on the coated button, it must be turned upside down. 
5.    Place the bottom part so that the metal eyelet on the upper part does through the crack on the bottom part (the back of the button). Squeeze the bottom part firmly. 


 

Do you have questions?
You have chosen the following product variant:
Size: 29 mm
One unit is: 4 pcs.

Choose variant
pcs.